Video scenes shots:
Watch the video:
Other videos by this author:
 |
A lathe milling aluminum Posted by: ryobiguy
Video duration: 82 seconds The lathe with 5/8" endmill plowing through some 1" 2011 aluminum in vice held in compound to make some D shaped washers. Lathe is Southbend from the 1916. Related: lathe, milling |
 |
Ryobi 582 Offset Printing Press 2 color Posted by: ryobiguy
Video duration: 102 seconds Printing press in action. 17.5"x22.5" sheet size 13,000/hour max, 2 color. Can do tight registration 4 color process printing. Very much a Rube Goldberg machine, fascinating to watch it grab just one sheet at a time and position it just perfectly in a quarter of a second! Related: delivery, feeder, ink, machine, offset, paper, press, printing, ryobi, sheet, stream |
 |
Guitar pickup winder, coil winder, automatic traversal Posted by: ryobiguy
Video duration: 57 seconds First prototype, stepper motor linear wire guide for automatic traversal in a coil winder, specifically for a guitar pickup winder. This is for winding super fine enamel coated wire, which slips over the thread groove in the slippery plastic. Related: avr, butterfly, coil, guitar, pickup, stepper, winder |
 |
Lathe cutting aluminum Posted by: ryobiguy
Video duration: 56 seconds Roughing down some 2024. Noises are from stepper motor (electronic leadscrew,) and from the belt drive. Related: bend, cut, lathe, motor, south, stepper, turning |
 |
Lathe stepper motor software test Posted by: ryobiguy
Video duration: 23 seconds Low speed synchronization test of the lathe carriage that is electronically geared to the spindle at 10 threads/inch, using EMC^2 on Linux and a custom HAL module I wrote for it. The spindle is encoded by a sensor on a gear that has 66 teeth, so it's only 66 cycles/rev. Related: els, emc, encoder, lathe, stepper, threading |
